Cooper Motion Sensor Light Switch Instructions

Switch or in the unlikely event of a failure of the motion sensor.

Cooper motion sensor light switch instructions.

Install the sensor loosely using the mounting screws provided. Turn the light control knob all the way clockwise to the moon symbol dusk position fig. The sensor green wire will connect to the ground wire in the wallbox. When unit stabilizes about 1 minute the sensor is ready to detect motion.

The sensor blue wire is not used and should be capped off with a wire nut. Turn the power back on at the circuit breaker. Repeat this procedure to restore normal operation. Instructions for a cooper outdoor motion detector location.

Reposition the sensor. The sensor black wire will connect to the hot wire in the wallbox. In either mode the. There is motion in the detection zone.

Match up screw holes on the cover plate with the junction. Automatically release the button while the led is blinking. The sensor red wire will connect to the wire which goes to the light fixture. Install your fixture near a doorway or pathway to.

Set the switch to the auto mode. Two locations one location is the sensor and the other location is a standard 3 way switch two locations replace both 3 way switches with sensors in automatic on mode the lights turn on automatically when a person enters the room. The lights will turn off 5 seconds after motion is no longer detected. Select a location that is 6 to 8 feet above ground level.

Turn off power at the main fuse or breaker box. Make sure the sensor is not picking up moving objects such as trees traffic etc. Press and hold the on off button for 10 seconds until the indicator led blinks for the second time the led will also blink at the 5 second point. Turn the light switch to the off position for 40 seconds and then turn back to the on position.

Motion is detected the lights will turn on. Unit is in override mode if there is no motion.