Continuous Geared Hinge Installation

The geared continuous hinge has no pin.

Continuous geared hinge installation.

Pemko anodized aluminum full surface continuous geared hinges have one leaf attached to the face of a door and the other leaf attached to the face of a door frame. A tip from select hinges. Line up the hinge with the door side. The following will void the product warranty and nullify the fire rating.

These characteristics make continuous hinges suitable for high use and high traffic doors. Heavy duty concealed leaf hinge. 780 series concealed leaf continuous hinge. The two are held in place by a full length cover channel and rotate on a series of bearings.

Installation instructions concealed continuous geared hinges important. The hinge must be installed with the cut end on the bottom. When installing a full surface geared continuous hinge if there is an obstruction on the face of the jamb leg for example some type of fascia that is too much to trim the cap does not have to be centered. Attaching the hinge to the frame.

When installing a continuous hinge the door will settle approximately 1 16. Use of any fasteners other than those supplied by the manufacturer. This allows any chips to work out after installation. Pemko half mortise continuous aluminum geared hinges.

With the hinge in the open position use a shim to position the top end of the hinge 1 8 below the header to allow for door clearance. These hinges have many applications including airports stadiums storefronts schools hospitals offices hotels and many other commerc. They have geared teeth that come together under a cap the entire length of the door. Geared hinges are a type of continuous hinge used mostly on high traffic commercial use doors.