Connect Pressure Washer To Water Tank

Water tank must be a 100 gallon capacity or more.

Connect pressure washer to water tank.

Squeeze the spray nozzle trigger to let out water pressure. Locate the banjo fitting on the tank and connect an inline to the pvc. Before you can run a pressure washer off a water tank you need to ensure the two are correctly connected. This is not an ideal solution because pressure washers emit gallons of water every minute so you are likely to empty the bucket very quickly.

Run the water for about a minute. Water tank must be elevated above the level of the pump. Ball valve should be full port valve. Attach a high pressure hose between spray wand and pressure washer.

The next step is to connect the ball valve to the barb connector and finally to the hose. Depress the trigger on the spray wand to purge any water or air from the unit. When the frame and the base are installed install the tank and other. Pressure washer pump must be positioned close to the water tank not more than 5 ft away water supply line must be at least 2 diameter.

First you need to ready the frame that will hold your engine. With the correct suction hose you can simply place one end of the hose into a bucket of water and connect the other to the pressure washer. Ensure it is firmly held in place by securing it with teflon tape. Attach a garden hose between water supply and pressure washer.

You need to do this to prime the system and remove air from it. Set up your water pump and filter. Although you can use. Inlet filter 40 mesh max.

Turn the water on.